[New 300-101 PDF]High Quality Braindump2go 300-101 Dumps 332q Free Share[161-170]

2017 New Cisco 300-101 Exam Dumps with PDF and VCE 332Q&As Free Updated in www.Braindump2go.com  Today!
100% Real Exam Questions! 100% Exam Pass Guaranteed!

1.|2017 New Version 300-101 Exam Dumps (PDF & VCE) 332Q&As Download:
http://www.braindump2go.com/300-101.html

2.|2017 New Version 300-101 Exam Questions & Answers Download:
https://drive.google.com/drive/folders/0B75b5xYLjSSNQTNkemNFVU5QeDg?usp=sharing

 

QUESTION 161
On which two types of interface is Frame Relay switching supported? (Choose two.)

A.    serial interfaces
B.    Ethernet interfaces
C.    fiber interfaces
D.    ISDN interfaces
E.    auxiliary interfaces

Answer: AD

QUESTION 162
In IPv6, SLAAC provides the ability to address a host based on a network prefix that is advertised from a local network router. How is the prefix advertised?

A.    routing table
B.    router advertisements
C.    routing protocol
D.    routing type

Answer: B

QUESTION 163
Refer to the exhibit. Which option prevents routing updates from being sent to the access layer switches?
 

A.    DWS1(config-router)# passive-interface default
DWS2(config-router)# passive-interface default
B.    ALS1(config-router)# passive-interface default
ALS2(config-router)# passive-interface default
C.    DWS1(config-router)# passive-interface gi1/1
DWS1(config-router)# passive-interface gi1/2
DWS2(config-router)# passive-interface gi1/1
DWS2(config-router)# passive-interface gi1/2
D.    ALS1(config-router)# passive-interface gi0/1
ALS1(config-router)# passive-interface gi0/2
ALS2(config-router)# passive-interface gi0/1
ALS2(config-router)# passive-interface gi0/2

Answer: C

QUESTION 164
Refer to the exhibit. Which option prevents routing updates from being sent to the DHCP router, while still allowing routing update messages to flow to the Internet router and the distribution switches?
 

A.    DHCP(config-router)# passive-interface default
DHCP(config-router)# no passive-interface Gi1/0
Internet(config-router)# passive-interface Gi0/1
Internet (config-router)# passive-interface Gi0/2
B.    Core(config-router)# passive-interface Gi0/0
Core(config-router)# passive-interface Gi3/1
Core(config-router)# passive-interface Gi3/2
DHCP(config-router)# no passive-interface Gi1/0
C.    Core(config-router)# passive-interface default
Core(config-router)# no passive-interface Gi0/0
Core(config-router)# no passive-interface Gi3/1
Core(config-router)# no passive-interface Gi3/2
D.    Internet(config-router)# passive-interface default
Core(config-router)# passive-interface default
DSW1(config-router)# passive-interface default
DSW2(config-router)# passive-interface default

Answer: C

QUESTION 165
A network engineer is considering enabling load balancing with EIGRP.
Which consideration should be analyzed?

A.    EIGRP allows a maximum of four paths across for load balancing traffic.
B.    By default, EIGRP uses a default variance of 2 for load balancing.
C.    EIGRP unequal path load balancing can result in routing loops.
D.    By default, EIGRP performs equal cost load balancing at least across four equal cost paths.

Answer: D

QUESTION 166
The OSPF database of a router shows LSA types 1, 2, 3, and 7 only.
Which type of area is this router connected to?

A.    stub area
B.    totally stubby area
C.    backbone area
D.    not-so-stubby area

Answer: D

QUESTION 167
An engineer is configuring a GRE tunnel interface in the default mode. The engineer has assigned an IPv4 address on the tunnel and sourced the tunnel from an Ethernet interface. Which option also is required on the tunnel interface before it is operational?

A.    tunnel destination address
B.    keepalives
C.    IPv6 address
D.    tunnel protection

Answer: A

QUESTION 168
Which protocol is used in a DMVPN network to map physical IP addresses to logical IP addresses?

A.    BGP
B.    LLDP
C.    EIGRP
D.    NHRP

Answer: D

QUESTION 169
Which two routing protocols are supported by Easy Virtual Network? (Choose two.)

A.    RIPv2
B.    OSPFv2
C.    BGP
D.    EIGRP
E.    IS-IS

Answer: BD

QUESTION 170
Which statement is true?

A.    RADIUS uses TCP, and TACACS+ uses UDP.
B.    RADIUS encrypts the entire body of the packet.
C.    TACACS+ encrypts only the password portion of a packet.
D.    TACACS+ separates authentication and authorization.

Answer: D


!!!RECOMMEND!!!

1.|2017 New Version 300-101 Exam Dumps (PDF & VCE) 332Q&As Download:
http://www.braindump2go.com/300-101.html

2.|2017 New Version 300-101 Study Guide Video:
https://youtu.be/7DNc6Sp9S6E

Comments are closed.